Photocentric Hard Black UV resin comes in two forms SLA laser compatible SLA resin for use with higher powered UV laser SLA printers and is optimised for 405nm and DLP compatible resin for use with DLP printers at wavelengths of 380-405nm. Their Hard UV laser photopolymer is ideal where hard objects are required that will not bend or compress. They have very high tensile shear properties and have very low elongation.
By using their hard resin you will benefit from fast exposure times with a wide exposure latitude so that you will achieve good results over a wider range of exposure conditions. The other great benefit is the price! Photocentric hard resin is considerably cheaper than comparable UV laser or DLP resins. So get great results at a great price.
About Photocentric UV laser resins
Photcentric’s UV laser resins are designed to work with a wide range of laser printers accommodate both open and closed mode resin profiles. Their UV laser resins are formulated to work at 405nm and so can be used with popular laser printers like the Form 1+, Form 2 & Moai. For lower powered printers their DLP range of resins should be used as these can operate from 380nm-405nm. Photocentric UV resins come in a wide variety of material properties: Hard, Firm, High Tensile, Flexible and Castable formulations.
The solid material is tough, durable and long lasting provided it is stored in dry conditions away from strong UV light.
Follow the procedures laid out in your 3D Laser printer ́s user manual. Polymer should be poured into the tray away from direct sunlight. Polymer can be reused but should be poured through a filter to remove solid lumps. Keep hood on at all times. Liquid polymer is soluble in water and soap. After cleaning, objects surface tack can be removed by leaving under water in UV for 20 minutes or longer. If any surface tack persists you can remove it by wiping the parts with IPA.
Hard resin data sheets
Hard UV Resin specifications
- Material: UV Laser SLA Resin or UV DLP resin
- Volume: 1kg bottles
- Compatible Printers: Form 1+, Form 2, Moai etc…
- Wavelength: 405nm (SLA); 380nm-405nm (DLP)
- Viscocity: 230 cPs
- Hardness (after post exposure): 77Dshore
- Tensile Strength (ASTM D638 after post exposure): 35 MPa
- Tensile Strength (ASTM D638 before post exposure): 15 MPa
- Tensile Modulus (ASTM D638 after post exposure): 2060 MPa
- Elongation at break (ASTM D638): 4%
- Heat deflection temp (ASTM D648): 60°C
- Density: 1.19 g/cm3
- Storage temperature: 10-50°C
*Note that colours are representative
** Photocentric colour availability can vary a lot so please check – Tel: 01453 808026