Replacement Brass Cetus Nozzle. This is the latest version (V5) of the Cetus Nozzle where the PTFE lining is fitted within the heat break.
These nozzles are sold separately in 0.2mm, 0.4mm and 0.6mm diameters.
The nozzles are compatible with:
- Cetus Mk1
- Cetus Mk2
- Cetus Mk3
Use the 0.6mm nozzle for printing with a layer thickness of 0.3mm and above. The 0.2mm nozzle is for printing with a layer thickness of 0.05mm & 0.07mm. The Cetus is optimised to print these layer thicknesses with the respective diameter nozzle.
Steps to replace your nozzle
- Whilst the hotend is cold remove the PEEK cap by hand. If it is difficult to remove you may use pliers but be careful not to damage the cap.
- Use the nozzle wrench to then unscrew your old nozzle from your Cetus and remove.
- Screw in your new nozzle
- Replace the PEEK cap